News
How to change the rear wheel of the Nitro rollator.
drive nitro Nitro rear wheel nitro rollator how to Nitro rollator repair
1. Lock the wheel. 2. Using a small flat end screw driver pry off the hub cab. 3. Using a 13mm socket remove the locknut from the axle. 4. Release the loop brake and slide off the wheel. Install the new wheel following the steps 1 to 4 in reverse.
How to replace the 796 knee scooter brakes
Removal: 1. Clip the ferrule off the end of the cable. 2. Loosen the lock nut. 3. Pull the cable through the lock nut. 4. Disconnect the cable from the lever by pulling the sleeve out and guiding the cable through the slot in the lever. 5. Pull the lever and expose the cable end, and slide the ferrule out of the retainer 6. Pull the cable sleeve out of the guides (3). Installation: 1. Thread the cable and sleeve through all 3 cable guides. 2. Pass...
How to repair the Vive Health 3 and 4 wheel scooter control panel
SAFETY NOTE: Make sure to remove the battery pack before starting ANY electrical system repair.
What PDI products are effective against COVID-19
covid delta variant pdi covid wipes pdi wipes what wipes are effective against covid
Information provided by PDI: https://pdihc.com/faq/do-you-have-any-products-effective-against-2019-novel-coronavirus-2019-ncov/The CDC updated their recommendations to refer to List N on the EPA website for EPA-registered disinfectants that have qualified under EPA’s emerging viral pathogens program for use against SARS-CoV-2. Per the EPA’s website, “List N includes products that meet the EPA’s criteria for use against SARS-CoV2 , the cause of COVID-19. This list includes products with emerging viral pathogen claims and those with human coronavirus claims.’ The following PDI products have EPA approval for the SARS-CoV-2 claim and are on List N (Products with Emerging Viral Pathogens and Human Coronavirus claims for use against SARS-CoV-2):...
How to change the front wheel on an old style Nitro rollator
change Nitro front wheel Nitro front wheel replacement nitro rollator how to
1. Pry off the dust cap to expose the fork stem nut. 2. Remove the fork stem nut. (19mm socket) 3. The screw that holds the hub cap on to the fork axle is either an Allen or a Torx head. Verify that the correct tool and size is being used as not to round out the head of the screw. 4. Remove the hub cap from the front wheel. 5. Install the hub cap screw back onto the fork axle. Screw it down as far as possible, DO NOT FORCE THE SCREW. 6. Open...