Please refer to the parts diagram for all available replacement parts. Replacement parts ship directly from Drive Medical and are subject to their stock availability.

 Please make sure that you have selected the correct number for the part that you need above.

Before you order: Check the number of brake handles on your Drive knee scooter. The 790 has 2 brake handles and the 796 has 1. The parts on these models are not the same.

12 - Knee pads are sold by the each

25 - NOT AVAILABLE Axle Retaining Bolts 95012R79525

26 - Not available. The basket mount is now part of the column, #23

 27 - The basket will not work on other knee walkers. The mounting bracket is welded to the column.

Drive parts are series specific and not interchangeable, unless labelled, with other drive series or other brands. Returns will not be accepted for intended use under these circumstances. If design changes are noted on any parts, please contact us to make sure you have the correct part for your serial number.

Brake Replacement

 

Removal:

1. Clip the ferrule off the end of the cable.

 

 

 

2. Loosen the lock nut.

 

3. Pull the cable through the lock nut.

 

4. Disconnect the cable from the lever by pulling the sleeve out and guiding the cable through the slot in the lever.

 

5. Pull the lever and expose the cable end, and slide the ferrule out of the retainer

 

6. Pull the cable sleeve out of the guides (3).

 

 

 

 Installation:

1. Thread the cable and sleeve through all 3 cable guides.

 

2. Pass the cable through the nut. DO NOT TIGHTEN IT YET.

 

3. Hook the upper ferrule into the lever retainer.

4. Thread the cable through the slot in the lever, making sure the sleeve remains in the adjuster seat.

5. Now go back to the cable end at the brake, and, using pliers, pull the cable tight, and, while holding tension, tighten the retaining nut.

6. If necessary, the brake can be adjusted at the bottom threaded adjuster,

Finer adjustments can be done at the brake handle.